WatchGuard x1000 参考指南

Policy Manager

Reference Guide

167

Enter a port number to restrict the routing policy to a single 
source port.

Closes this dialog box and saves any changes.

Advanced NAT Settings dialog box 

Server-Based tab

Enable this checkbox to allow service-based NAT, which is 
dynamic NAT on a per-service basis. Once enabled, use the 
Outgoinb tab of each service icon to refine your NAT 
configuraiton.

1-to-1 NAT Setup tab

Check to enable 1-to-1 NAT. This type of NAT redirects packets 
sent to one range of addresses to a different range of addresses.

Lists the IP addresses to be redirected.

Select to add other IP addresses to be redirected. The 1-to-1 
Mapping dialog box opens.

Select to edit the IP addresses choosen from the list above. The 1-
to-1 Mapping dialog box opens.

Select to remove IP addresses choosen from the list above.

Dynamic NAT Exceptions tab

Dynamic NAT Exceptions allows you to configure exceptions to 
simple dynamic NAT and service-based dynamic NAT. Dynamic 
NAT Exceptions do not apply to 1-to-1 NAT.