WatchGuard x1000 用户指南
Chapter 6: Managing and Monitoring the Firebox
82
WatchGuard Firebox System
6
To cancel the changes you have made in this dialog box
since opening it, click Reset to Defaults.
since opening it, click Reset to Defaults.
Copying messages to another application
To copy a log message so you can paste it into another
application such as email or Notepad, right-click the mes-
sage and select Copy Selection. You can then open up the
other application and paste in the message.
application such as email or Notepad, right-click the mes-
sage and select Copy Selection. You can then open up the
other application and paste in the message.
Copying or analyzing deny messages
You can use several tools to copy and analyze deny mes-
sages:
•
sages:
•
To copy a deny message and paste it into an
application, use the procedure in the previous section.
application, use the procedure in the previous section.
•
To copy the source or destination IP address of a deny
message so you can paste it into another application,
right-click the message, select Source IP => Copy or
Destination IP => Copy.
message so you can paste it into another application,
right-click the message, select Source IP => Copy or
Destination IP => Copy.
•
To issue the ping command to a source or destination
IP address of a deny message, right-click the message
and select Source IP => Ping or Destination IP => Ping.
(When you issue this command, you are prompted to
enter the configuration passphrase.)
IP address of a deny message, right-click the message
and select Source IP => Ping or Destination IP => Ping.
(When you issue this command, you are prompted to
enter the configuration passphrase.)
•
To issue a traceroute command to a source or
destination IP address of a deny message, right-click
the message and select Source IP => Trace Route or
Destination IP => Trace Route. (When you issue this
command, you are prompted to enter the configuration
passphrase.)
destination IP address of a deny message, right-click
the message and select Source IP => Trace Route or
Destination IP => Trace Route. (When you issue this
command, you are prompted to enter the configuration
passphrase.)
Performing Basic Tasks with System Manager
The basic tasks you perform with System Manager are:
•
•
Running the QuickSetup Wizard