WatchGuard x1000 用户指南
Chapter 11: Intrusion Detection and Prevention
186
WatchGuard Firebox System
N
OTE
The Blocked Sites list applies only to traffic on the External
interface. Connections between the Trusted and Optional
interfaces are not subject to the Blocked Sites list.
interface. Connections between the Trusted and Optional
interfaces are not subject to the Blocked Sites list.
From Policy Manager:
1
On the toolbar, click the Blocked Sites icon
(shown at right).
(shown at right).
You can also select Setup => Intrusion Prevention=>
Blocked Sites. The Blocked Sites dialog box appears, as shown in
the following figure.
2
Click Add.
3
Use the Choose Type drop list to select a member type.
The options are Host IP Address, Network IP
Address, or Host Range.
The options are Host IP Address, Network IP
Address, or Host Range.
4
Enter the member value.
Depending on the member type, this can be an IP address or a
range of IP addresses. When typing IP addresses, type the digits
and periods in sequence. Do not use the TAB or arrow key to
jump past the periods. For more information on entering IP
addresses, see “Entering IP addresses” on page 43.
5
Click OK.
The Blocked Sites dialog box appears displaying the new site in
the Blocked Sites list.