Whirlpool WGD9270X 用户指南

Press and hold the SIGNAL button for 3 seconds to turn this 
feature off. 
NOTE: When the dryer is running and Control Lock is on, the 
dryer can be stopped by pressing the START/PAUSE button, 

 

but cannot be restarted until the control is unlocked.

On Automatic Cycles, you can change the Cycle or Dryness Level 
at any time before pressing START/PAUSE. 
On Timed Cycles, you can change the Cycles, adjust the time, 

 

or change the temperature setting at any time before pressing 
START/PAUSE.

■

Three short tones sound if an unavailable combination is 
selected. The last selection will not be accepted.

1. Press POWER. This ends the current cycle.
2. Select the desired cycle and options.
3. Press and hold START/PAUSE. The dryer starts at the 

beginning of the new cycle.

NOTE: If you do not press Start within 5 minutes of selecting 

 

the cycle, the dryer automatically shuts off.

On Timed Cycles, at any time, you may:

■

Adjust the time by pressing the More or Less Time buttons. 

■

Change the temperature setting by pressing the Temp button.

Keep dryer area clear and free from items that would obstruct the 
flow of combustion and ventilation air.

The lint screen is located in the door opening of the dryer. 

 

A screen blocked by lint can increase drying time.
To clean
1. Pull the lint screen straight up. Roll lint off the screen with your 

fingers. Do not rinse or wash screen to remove lint. Wet lint is 
hard to remove.

2. Push the lint screen firmly back into place.
IMPORTANT:

■

Do not run the dryer if the lint screen is loose, damaged, 
blocked, or missing. Doing so can cause overheating and 
damage to both the dryer and fabrics.

■

If lint falls off the screen into the dryer during removal, 

 

check the exhaust hood and remove the lint. See 

 

“Venting Requirements.”

Laundry detergent and fabric softener residue can build up 

 

on the lint screen. This buildup can cause longer drying times 

 

for your clothes, or cause the dryer to stop before your load is 
completely dry. 
Clean the lint screen with a nylon brush every 6 months, or more 
frequently, if it becomes clogged due to a residue buildup.
To wash
1. Roll lint off the screen with your fingers.
2. Wet both sides of lint screen with hot water.
3. Wet a nylon brush with hot water and liquid detergent. Scrub 

lint screen with the brush to remove residue buildup.

4. Rinse screen with hot water.
5. Thoroughly dry lint screen with a clean towel. Replace screen 

in dryer.

1. Make a paste with powdered laundry detergent and very 

warm water.

2. Apply paste to a soft cloth.

Apply a liquid, nonflammable household cleaner to the stained 
area and rub with a soft cloth until all excess dye and stains 
are removed.

3. Wipe drum thoroughly with a damp cloth.
4. Tumble a load of clean cloths or towels to dry drum.
NOTE: Garments that contain unstable dyes, such as denim blue 
jeans or brightly colored cotton items, may discolor the dryer 
interior. These stains are not harmful to your dryer and will not 
stain future loads of clothes. Dry unstable dye items inside out to 
avoid transfer of dye.