Whirlpool WED6200S 用户指南

You can change Automatic and Timed Cycles, Modifiers, and 
Options anytime before pressing Start. 

■

Three short tones sound if an unavailable combination is 
selected. The last selection will not be accepted.

1. Press PAUSE/CANCEL twice.
2. Select the desired cycle and options.
3. Press START. The dryer starts at the beginning of the new 

cycle.

NOTE: If you do not press Start within 5 minutes of selecting the 
cycle, the dryer automatically shuts off.

You can change an Option or Modifier anytime before the selected 
Option or Modifier begins.
1. Press PAUSE/CANCEL once.
2. Select the new Option and/or Modifiers.
3. Press START to continue the cycle.
NOTE: If you happen to press PAUSE/CANCEL twice, the 
program clears and your dryer shuts down. Restart the selection 
process.

If all of your loads on all Auto Dry cycles are consistently not as 
dry as you would like, you may change the preset Dryness Level 
settings to increase the dryness. This change will affect all of your 
Auto Dry cycles.
Your Dryness Level settings can be adjusted to adapt to different 
installations, environmental conditions or personal preference. 
There are 3 drying settings: 1 (factory preset dryness level), 
2 (slightly dryer clothes, approximately 15% more drying time), 
and 3 (much dryer clothes, approximately 30% more drying time). 
1. The Dryness Level settings cannot be changed while the dryer 

is running.

2. Press and hold the DRYNESS button for 5 seconds. The dryer 

will beep, and “CF” will be displayed for 1 second followed by 
the current drying setting.

3. To select a new drying setting, press the DRYNESS button 

again until the desired drying setting is shown. 

 

NOTE: While cycling through the settings, the current setting 
will not flash, but the other settings will flash.

4. Press START to save the drying setting.
5. The drying setting you selected will become your new preset 

drying setting for all Auto Dry cycles.

Use the Drying Rack to dry items such as sweaters and pillows 
without tumbling. The drum turns, but the drying rack does not 
move. 
If your model does not have a drying rack, you may be able to 
purchase one for your model. To find out whether your model 
allows drying rack usage and for information on ordering, please 
refer to the front page of the manual or contact the dealer from 
whom you purchased your dryer. 
NOTE: The drying rack must be removed for normal tumbling. Do 
not use the automatic cycle with the drying rack.
To use the drying rack

1. Open dryer door.

A

2. Place drying rack inside dryer drum, positioning the back wire 

on the ledge of the inner dryer back panel. Push down on front 
edge of drying rack to secure at the front of the dryer.  

3. Put the wet items on top of the drying rack. Leave space 

between the items so air can reach all the surfaces.

NOTE: Do not allow items to hang over the edge of the drying 
rack. 

4. Close the door.
5. Press the POWER button.
6. Select Timed Dry Cycle and select a temperature (see 

following chart). Items containing foam, rubber or plastic must 
be dried on a clothesline or by using the Air Only temperature 
setting.

7. You must select a time by pressing TIME ADJUST Up or 

Down. Reset time as needed to complete drying. Refer to the 
following table.

8. Press (and hold) START button (about 1 second).