Wren Associates sdp6 安装指导

SDP6-IP, IP-Enabled 6” Solution Dome 

 

 

www.wrenassociates.com (800) 

881-2249 

7L257-revA 9/1/2006 

Page 1 of 3 

 

 
 

The IP-Enabled Pendant Solution Dome line delivers attractive, durable products 
for indoor security. Solution Domes are an excellent value------well-built, well-
priced and designed for easy installation and maintenance. 
 

•  #2 Phillips-head screwdriver 

•  Pliers (optional, for DC power) 

 

A.  Upper Housing Assembly 
B.  Encoder Module 
C.  Fixed Camera Bracket 
D.  Three-Piece Camera Mounting Bracket 
E.  6’’ Dome Assembly 
F.  Power Lead Extension and Connectors (not shown) 
G.  Wing Screw (not shown) 

 

Prior to installation and use of this product, please observe the 
following warnings 

1.  Installation and servicing should be done by qualified personnel, 

and all work done should conform to local codes. 

2.  Using replacement parts or accessories other than Wren may 

invalidate the warranty. 

3.  This unit is designed to operate on either IEEE 802.3af POE or 12VDC 

power. Do not bring any other voltages into the housing. 

4.  Make sure that the installation method is capable of supporting three 

(3)

 

times the weight of the SDP6-IP housing and enclosed contents. 

5.  Verify proper installation of cabling to support camera power and 

communication requirements for fixed camera applications.  

 

1.  Carefully unpack box and verify that all components listed are included 

[Figure 1]. 

2.  Remove the Dome and Trim Ring Assy from the upper housing by turning 

the assembly counter-clockwise, taking care that dome does not become 
scratched or damaged. 

3.  Remove the fixed camera bracket and the three 

(3) 

piece mounting 

bracket by removing the 3 wing nuts securing it to the SDP6 housing. 

4.  Run CAT5 (and, optionally, 12VDC leads) to the location where the 

assembly is to be installed. 

 

POE power must be IEEE 802.3af compliant.  Optional 12VDC power must be from 
a regulated power source and of the correct polarity (center positive). (See Master 
Power Supply Instructions for wiring/installation instructions.) 

SDP6-

IP