3com S7906E 安装指导
1-37
To do…
Use the command...
Remarks
Enter the view of the interface
directly connected to the
protected node or PLR
directly connected to the
protected node or PLR
interface
interface-type
interface-number
––
Enable RSVP hello extension
on the interface
on the interface
mpls rsvp-te hello
Required
Disabled by default
Disabled by default
RSVP hello extension is configured to detect node failures caused by problems such as signaling error
other than failures caused by link failures.
other than failures caused by link failures.
Configuring Cooperation of MPLS RSVP-TE and BFD
Cooperation of MPLS RSVP-TE and BFD is mainly used for link status detection of FRR. When BFD
detects a link failure, it immediately notifies the failure to FRR, which will then reroute traffic from the
primary LSP to the bypass LSP.
detects a link failure, it immediately notifies the failure to FRR, which will then reroute traffic from the
primary LSP to the bypass LSP.
Follow these steps to configure cooperation of MPLS RSVP-TE and BFD:
To do…
Use the command...
Remarks
Enter system view
system-view
––
Enter view of the interface
enabled with MPLS RSVP-TE
enabled with MPLS RSVP-TE
interface
interface-type
interface-number
––
Enable BFD for MPLS
RSVP-TE
RSVP-TE
mpls rsvp-te bfd enable
Required
Disabled by derfault
Disabled by derfault
Configuring the FRR polling timer
The protection provided by FRR is temporary. Once a protected LSP becomes available again or a new
LSP is established, traffic will be switched to the protected or new LSP. After this switchover, the PLR
polls available bypass tunnels for the best one at the regular interval specified by the FRR polling timer:
LSP is established, traffic will be switched to the protected or new LSP. After this switchover, the PLR
polls available bypass tunnels for the best one at the regular interval specified by the FRR polling timer:
Follow these steps to configure the FRR polling timer:
To do…
Use the command...
Remarks
Enter system view of the PLR
node
node
system-view
––
Enter MPLS view
mpls
––
Configure the FRR polling timer
mpls te timer fast-reroute
[ second ]
[ second ]
Optional
The FRR polling timer is 300
seconds by default.
The FRR polling timer is 300
seconds by default.