3com S7906E 安装指导

 

1-3 

Enter system view 

system-view 

— 

Manually restart the SMB 

slave restart 

Required 

 

After the SMB has restarted, the AMB will perform initial synchronization on the SMB. During this 

process, the system does not respond to your input. After the initial synchronization is completed, you 

can execute all the configuration commands on the AMB and the AMB and SMB will keep a real-time 

synchronization process, meaning your configuration on the AMB will be copied to the SMB to ensure 

the consistency of the current configuration of the AMB and SMB. 

 

Enter system view 

— 

Enable the manual switchover 
between the AMB and SMB 

slave switchover { disable | 
enable } 

Optional 

Enabled by default 

Manually configure switchover 
between the AMB and SMB 

Required 

 

The original AMB will be restarted if an AMB and SMB switchover is performed. Therefore, ensure the 

consistency of the software version of the AMB and SMB before performing an AMB and SMB 

switchover. By default, if the versions of the AMB and SMB are not consistent, the original AMB cannot 

be restarted; to perform an AMB and SMB switchover in case that their versions are not consistent, 

configure to ignore version check of the SMB. 

 

Display the switchover state 
(independent mode) 

display switchover state 
[ slot slot-number ] 

Display the switchover state 
(IRF mode) 

display switchover state 
[ chassis chassis-number slot 

slot-number ] 

Available in any view