3com S7906E 参考指南

 

1-11 

Use the multicast ipv6 routing-enable command to enable IPv6 multicast routing.  

Use the undo multicast ipv6 routing-enable command to disable IPv6 multicast routing.  

IPv6 multicast routing is disabled by default.  

Note that:  

z 

You must enable IPv6 multicast routing before you can carry out other Layer 3 IPv6 multicast 

commands.  

z 

The device does not forward any IPv6 multicast packets before IPv6 multicast routing is enabled. 

# Enable IPv6 multicast routing.  

<Sysname> system-view 

[Sysname] multicast ipv6 routing-enable 

reset multicast ipv6 forwarding-table { { ipv6-source-address [ prefix-length ] | ipv6-group-address 

[ prefix-length ] | incoming-interface { interface-type interface-number | register } } * | all } 

User view 

2: System level 

ipv6-source-address: IPv6 multicast source address.  

ipv6-group-address: IPv6 multicast group address, in the range of FFxy::/16, where x and y represent 

any hexadecimal number from 0 to F.  

prefix-length: Prefix length of an IPv6 multicast group or an IPv6 multicast source address. For an IPv6 

multicast group address, this argument has an effective value range of 8 to 128; for an IPv6 multicast 

source address, this argument has an effective value range of 0 to 128. The system default is 128 in 

both cases.  

incoming-interface: Specifies to clear IPv6 multicast forwarding entries of which the incoming 

interface is the specified one.  

interface-type interface-number: Specifies an interface by its name and number. 

register: Specifies the register interface.  

all: Clears all forwarding entries from the IPv6 multicast forwarding table.  

Use the reset multicast ipv6 forwarding-table command to clear forwarding entries from the IPv6 

multicast forwarding table.