3com S7906E 参考指南
1-4
[Sysname] multicast-vlan ipv6 100
[Sysname-ipv6-mvlan-100] port gigabitethernet 2/0/1 to gigabitethernet 2/0/5
subvlan (IPv6 multicast VLAN view)
Syntax
subvlan vlan-list
undo subvlan { all | vlan-list }
View
IPv6 multicast VLAN view
Default Level
2: System level
Parameters
vlan-list: Specifies a VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to
end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The effective range of a
VLAN ID is 1 to 4094.
all: Deletes all the sub-VLANs of the current IPv6 multicast VLAN.
Description
Use the subvlan command to configure sub-VLAN(s) for the current IPv6 multicast VLAN.
Use the undo subvlan command to remove the specified sub-VLAN(s) or all sub-VLANs from the
current IPv6 multicast VLAN.
An IPv6 multicast VLAN has no sub-VLANs by default.
Note that:
z
The VLANs to be configured as the sub-VLANs of the IPv6 multicast VLAN must exist and must not
be IPv6 multicast VLANs or sub-VLANs of another IPv6 multicast VLAN.
z
The number of sub-VLANs of the IPv6 multicast VLAN must not exceed the system-defined limit
(an S7900E series Ethernet switch supports up to five multicast VLANs, and supports up to 4000
sub-VLANs for each multicast VLAN. The total number of sub-VLANs for all multicast VLANs on
the switch cannot exceed 4000.).
Examples
# Configure VLAN 10 through VLAN 15 as sub-VLANs of IPv6 multicast VLAN 100.
<Sysname> system-view
[Sysname] multicast-vlan ipv6 100
[Sysname-ipv6-mvlan-100] subvlan 10 to 15