3com S7906E 参考指南
1-30
The active/standby mode of service ports is only applicable when the S7903E, S7906E, S7906E-V, or
S7910E switch uses LSQ1SRP2XB or LSQ1SRP12GB to operate in dual-SRPU mode.
Examples
# Enable active/standby mode for service ports on SRPUs.
<Sysname> system-view
[Sysname] strict-standby enable
switch-mode (for SRPU)
Syntax
When the SRPU is LSQ1SRP1CB:
switch-mode
{
l2-enhanced
|
standard-bridging
|
standard-routing
}
undo switch-mode
When the SRPU is LSQ1SRP2XB, LSQ1SRPB, or LSQ1MPUA:
switch-mode
{
l2-enhanced
|
standard
}
undo switch-mode
View
System view
Default Level
2: System level
Parameters
l2-enhanced: Indicates the enhanced Layer 2 forwarding mode with the MAC extension function when
the SRPU is LSQ1SRP1CB, and the enhanced Layer 2 forwarding mode when the SRPU is
LSQ1SRP2XB, LSQ1SRPB, or LSQ1MPUA.
standard: Indicates the standard forwarding mode.
standard-bridging: Indicates the standard forwarding mode with the MAC extension function.
standard-routing: Indicates the standard forwarding mode with the route extension function.
Description
Use the switch-mode command to configure the traffic forwarding mode of an SRPU.
Use the undo switch-mode command to restore the default traffic forwarding mode of the SRPU.
z
The default traffic forwarding mode of LSQ1SRP1CB is standard-routing.
z
The default traffic forwarding mode of LSQ1SRP2XB, LSQ1SRPB, or LSQ1MPUA is standard.