3com S7906E 参考指南

 

1-48 

ip-address: IP address of a peer. 

hop-count: Maximum hop count, in the range 1 to 255. The default is 64. 

Use the peer ebgp-max-hop command to allow establishing an EBGP connection with a peer/peer 

group that is on an indirectly connected network. 

Use the undo peer ebgp-max-hop command to restore the default. 

By default, this feature is disabled. 

You can use the argument hop-count to specify the maximum route hop count of the EBGP connection. 

# In BGP view, allow establishing the EBGP connection with the peer group test that is on an indirectly 

connected network. 

<Sysname> system-view 

[Sysname] bgp 100 

[Sysname-bgp] peer test ebgp-max-hop 

# In BGP-VPN instance view, allow establishing the EBGP connection with the peer group test that is 

on an indirectly connected network (the VPN has been created). 

<Sysname> system-view 

[Sysname] bgp 100 

[Sysname-bgp] ipv4-family vpn-instance vpn1 

[Sysname-bgp-vpn1] peer test ebgp-max-hop 

peer ip-address enable 

undo peer ip-address enable 

BGP view 

2: System level 

ip-address: IP address of a peer. 

Use the peer enable command to enable the specified peer.  

Use the undo peer enable command to disable the specified peer. 

By default, the BGP peer is enabled. 

If a peer is disabled, the router will not exchange routing information with the peer.