Xerox 4112 用户指南
Xerox 4112/4127 Copier/Printer System Administration Guide
2-6
2. Configuration
Configuration on the machine (SMB)
This section describes the configuration procedure to connect the
machine to Microsoft Networks (SMB). First enable the SMB port,
then set the IP address.
NOTE 1: The configuration can also be performed using the IP
configuration tools included in CentreWare Internet Services or
CentreWare Utilities.
configuration tools included in CentreWare Internet Services or
CentreWare Utilities.
NOTE 2: Enable the SOAP port and the SNMP port in most cases.
1.
Enter the System Administrator Mode (Chapter 1 Entering the
System Administrator Mode on page 1-15
System Administrator Mode on page 1-15
)
2.
Enable the SMB port.
a. Select
a. Select
System Settings
.
b. Select
Connectivity & Network Setup
.
c. Select
Port Settings
.
d. Select
SMB
and then select
Change Settings
.
e. Select
Port Status
and select
Change Settings
.
f. Select
Enable
and then select
Save
.
3.
If necessary, set the IP Address (Chapter 1 Setting the IP
address. on page 1-17).
address. on page 1-17).
4.
Exit the System Administrator Mode (Chapter 1 Exiting the
System Administrator Mode on page 1-16).
System Administrator Mode on page 1-16).
5.
After the machine is restarted, print out the
Printer Settings
List
to confirm that the SMB port is enabled.
NOTE: If using the NetBEUI protocol, select NetBEUI as the
protocol used by SMB for the port configuration using CentreWare
Internet Services.
protocol used by SMB for the port configuration using CentreWare
Internet Services.
Configuration on the computer