Xerox 2101 用户指南

2.2 Loading Paper/Changing Paper Size of Paper Trays

Load the following paper in tray 5 (bypass): transparency, postcard, heavy weight paper and other
special and non-standard size paper that cannot be loaded in trays 1 - 4 and the optional tray 6
(HCF).
When making copies onto SRA3 (320×450mm/12.6×17.7") or 12×18" paper, shift the paper guide on
the bypass tray before copying.
Always remember to shift the paper guide back to its Standard position after the copying is done.

● For details on the type of paper that can be loaded in tray 5 (bypass), refer to “2.1 Paper to Use”.
● 2-sided copying cannot be done with tray 5 (bypass).
● For details on loading the side for copying (face up/down) and paper orientation, refer to “5.26 Copying With Covers” and

Open tray 5 (bypass).

If necessary, pull out the
extension flap. The extension flap
can be pulled out in two steps.

Check the position of the
paper guide, which is
located as shown in the
diagram on the right.

Usually, the paper guide should
be at its standard position.

When loading paper:

Proceed to Step 3

When changing the paper size:

(1)Loosen the screw on

the right of the paper
guide.

● If the paper guide has been moved

● Do not shift the paper guide unless