Xerox 5500 用户指南

If you are still unable to print, go to 

 or access 

PhaserSMART Technical Support through CentreWare IS:

Launch your web browser.

Enter the printer’s IP address in the browser’s Address field (http://xxx.xxx.xxx.xxx). 

Select Support. 

Click the PhaserSMART Diagnostic Tool link to access PhaserSMART.

Perform these steps only for Mac OS X, versions 10.1 and higher:

Open the Network Utility, then click the Ping tab.

Enter the printer’s IP address.

Click Ping. If you do not get a response, confirm that your TCP/IP settings are correct for 
your printer and computer.

For AppleTalk, follow the steps below. For TCP/IP proceed to Step 5.

From the printer’s front panel, verify that EtherTalk is enabled. If it is not, enable it in 
the front panel, then reset the printer.

Print the “Configuration Page” and verify that EtherTalk is enabled.

From the “Configuration Page”, verify the Zone. If you have multiple zones on your 
network, verify that your printer appears in the desired zone.

If you are still unable to print, go to 

 or access 

PhaserSMART Technical Support through CentreWare IS:

Launch your web browser.

Enter the printer’s IP address in the browser’s Address field (http://xxx.xxx.xxx.xxx). 

Select Support. 

Click the PhaserSMART Diagnostic Tool link to access PhaserSMART.

For more information, go to 

 to view these 

documents.

R1015020359

Installing the Printer for an Ethernet (TCP/IP) Connection in Mac OS X 
10.2.x.

R1015020365

Installing the Printer for an Ethernet (TCP/IP) Connection in Mac OS X 
10.3.1 (and later)

R1002050080

Setting up TCP/IP (DHCP) in Macintosh OS X

R1002049814

Setting up AppleTalk in Macintosh OS X

R1015020363

Installing the Printer for an AppleTalk Connection in Mac OS X 10.3.1 (and 
later)