Xerox 5550 用户指南

Depending on your region, the optional finisher is factory configured with either a 3-hole 
punch or a 2- / 4-hole punch unit. To determine which option is installed on your printer, print 
a Configuration Page from the control panel.

■

When the hole punch option is turned on, sheets that are sent to the Stacker Upper Tray or 
the Stacker Lower Tray are punched. 

■

When the hole punch option is turned off, no paper is punched.

■

When the printer detects that the punch waste box is full, a warning appears on the control 
panel, and printing continues without punching.

To select hole punching in a supported driver:

The default hole punching option is selected through the control panel or through 
CentreWare IS.

To set the default hole punching option on the control panel:

On the control panel, select 

, and then press the OK button.

Select 

, and then press the OK button.

Select 

, and then press the OK button to toggle it on or off.

If you have a 2-hole and 4-hole punch, then set 

 to 

 or 

.

Launch your web browser.

Enter your printer’s IP address in the browser’s Address field.

Click Properties.

In the left navigation tree, expand General and then click Printer Defaults.

Select On or Off in the Punch drop-down menu.

Select the desired number of holes in the Punch Holes drop-down menu. 

Click the Save Changes button.

Select the Paper Output tab.

Select Hole Punch or the number of holes in the Hole Punch 
drop-down list.

In the Print dialog box, select Finishing Options from the 
drop-down list.

Select the number of holes under Hole Punching.