Xerox 123 用户手册

This chapter describes how to use the Stored Programming feature to simplify multiple 
operations into a simple procedure. First, you register a series of operations in a job 
number. Later, you can select the job number to execute the stored operations when 
required. You can store operations (both on the touch screen and the control panel) up 
to immediately before pressing the <Start> button on the control panel.
NOTE: You cannot store operations performed on the [Setup Menu] screen.

Follow the steps below to select and execute a job number.

Press the <All Services> button 
on the control panel.

Select [Stored Programming] on 
the touch screen.

Select a job number to be 
executed.

Change the settings as necessary.

Press the <Start> button on the control panel. 

NOTE: On the [Stored Programming] screen, only job numbers that have been 
programmed are active and selectable.

You can store up to 58 consecutive operations in each job number, up to the total of 40 
job numbers. To register the required operations in a job number, follow the steps 
below.
NOTE: A job number remembers not only operations performed on the touch screen 
but also the buttons pressed on the control panel.

NOTE: If, after a job has been stored in Stored Programming, you then change  the 
default settings in System Settings, or make changes to Job Flow Sheet, Job 
Template, Address Book, Comment, etc., the operation registered for each job will 
also change.