Xerox C118 用户指南

Select [SMB] by selecting [

S] or [T] and then press the <Enter> button.

Select [Port Status] by selecting [

S] or [T]  and then press the <Enter> button.

Select [Enable] by selecting [

S] or [T]  and then press the <Enter> button.

If necessary, you may change the following settings for SMB:

•

Transport Protocol

•

Print Mode

•

PJL

•

TBCP Filter

Next, establish TCP/IP if you use an IP address for a network.

If IP address setting is unnecessary, press the <Login/Out> button to go to Workstation 
Setup on page 67.

Press the <Exit> button once or twice to display the [Network/Port] screen.

Select [TCP/IP Settings] by selecting  [

T] or [S]  and then press the <Enter> 

button.

Select [Get IP Address] by selecting  [

T] or [S] and then press the <Enter> 

button.

Select [DHCP/Autonet], [DHCP], [BOOTP], [RARP], or [Manual] by selecting  [

T] 

or [

S] and then press the <Enter> button.

NOTE: Use the DHCP server together with the Windows Internet Name Service 
(WINS) server.

If you selected [Manual] in step 4, use the following steps to enter the IP address.

If you selected other than [Manual], press the <Login/Out> button and then go to 
Workstation Setup on page 67. 

Press the <Exit> button.

Select [IP Address] by selecting  [

T] or [S] and then press the <Enter> button.

Use the numeric keypad to enter the IP address in the format “xxx.xxx.xxx.xxx”.

NOTE: Press the <

J> button to move to the next section. Press the <I> button to 

return to the previous section.

NOTE: You cannot enter 127, 254, or 255 into the first section of the format.

Press the <Enter> button.

Press the <Exit> button.

Use the same steps as IP address setting to enter the subnet mask and gateway 
address.

NOTE: You can enter 000, 128, 192, 224, 240, 248, 252, 254, or 255 into each section 
as the values for the subnet mask.