Xerox 4050 用户指南
Guide to Performing Routine Maintenance
4-1
4.
Fuser lubricant and pressure roll
wiper
wiper
This chapter describes how to add fuser lubricant and how to
replace the pressure roll wiper on your system.
replace the pressure roll wiper on your system.
Adding fuser lubricant
The fuser assembly uses heat and pressure to fuse the print
image to the paper. It is critical that the fuser be kept lubricated
with fuser lubricant and that its reservoir be kept full. This
chapter describes the procedure for adding fuser lubricant to the
printer.
image to the paper. It is critical that the fuser be kept lubricated
with fuser lubricant and that its reservoir be kept full. This
chapter describes the procedure for adding fuser lubricant to the
printer.
Your service representative usually adds fuser lubricant.
However, you might choose to add the fuser lubricant yourself if
you have been trained in this procedure.
However, you might choose to add the fuser lubricant yourself if
you have been trained in this procedure.
To add fuser lubricant:
1. Open the printer doors.
2. Place a dropcloth on the floor under the fuser area.
WARNING
If any fuser lubricant is spilled, remove it immediately. Fuser
lubricant spills cause the floor to be very slippery.
lubricant spills cause the floor to be very slippery.