Xerox 4050 服务手册
2.
Setting up the LPS
This chapter describes the procedures for powering up and
logging onto the system.
logging onto the system.
Powering up the LPS
Follow this procedure to power up the system.
1. Select local or remote control of the system.
Press the Local button on the system controller panel to use
the internal power supply, or press the Remote button to use
a remote power supply. Contact your system administrator if
you are not sure what power supply to use.
the internal power supply, or press the Remote button to use
a remote power supply. Contact your system administrator if
you are not sure what power supply to use.
2. Press the System Power On button.
Either the Local status indicator or the Remote status
indicator lights show the power supply you selected (refer to
step 1).
indicator lights show the power supply you selected (refer to
step 1).
The Power On indicator lights.
A cursor appears on the system controller display for about
15 seconds while the system completes its initial diagnostic
tests, then READY $ appears on the display. There may be a
delay of up to 80 seconds before the $ appears.
15 seconds while the system completes its initial diagnostic
tests, then READY $ appears on the display. There may be a
delay of up to 80 seconds before the $ appears.
3. Boot the operating system software.
Your system may be set up to boot automatically after
powering on. This control is set by the system administrator.
In this case, you do not need to boot the operating system
software.
powering on. This control is set by the system administrator.
In this case, you do not need to boot the operating system
software.
If your system does not boot automatically, enter <B> at
the system controller keyboard.
the system controller keyboard.
XEROX 4050/4090/4450/4650 LPS OPERATOR GUIDE
2-1