Xerox 4050 服务手册

SETTING UP PRINT JOB SOURCES

CLOSE DOOR

2. Close the feed slot door by gently pulling down the handle

until the door latches shut.

The operator light goes off, and the following message
displays if the file is unprotected:

READY U

The following message displays if the file is protected:

READY F

Follow these steps to load a 1/4-inch cartridge tape:

1. Locate the 1/4-inch cartridge tape drive, mounted in the

system controller cabinet next to the floppy disk drive.

2. Press the cover release button.

The tape drive door partially opens.

3. Manually open the door completely.

4. Insert the cartridge (label facing to the left) into the feed slot.

5. Close the tape drive door.

The tape loads automatically.

If the tape has loaded properly, the LED indicator light is
green.

If the LED indicator light is flashing red, the tape has not
loaded properly.  Refer to the “Solving problems” chapter, or
see your system administrator.

Follow these steps to place a tape online:

1. If the following message displays, press the Ready button to

enable the read/write mode:

NT READY U

 or 

NT READY F

The ready indicator light comes on, and the 

nt ready

message changes to

 ready

.

If you have only the cartridge tape system for your system,
you are now ready to print jobs.  Your system is automatically
online to the LPS as long as the ready indicator light is on.

3-18

XEROX 4050/4090/4450/4650 LPS OPERATOR GUIDE