Xerox 8000AP 补充手册
C
ALIBRATION
36
If you deselect Apply to all calibration sets, you can choose to apply the current calibration to
a selected subset of the calibration sets on the server. To specify which sets, click Customize,
which opens the Apply To dialog box.
a selected subset of the calibration sets on the server. To specify which sets, click Customize,
which opens the Apply To dialog box.
Select or clear individual calibration sets, and then click OK.
If any of the selected calibration sets are not associated with an output profile, a warning
appears, but you can choose to apply the calibration measurements to that set anyway.
appears, but you can choose to apply the calibration measurements to that set anyway.
The calibration measurements are copied to the specified calibration sets at the end of the
calibration process when you click Apply.
calibration process when you click Apply.
Restoring default calibration measurements
Use the following procedure to return to factory default calibration measurements.
T
O
RESTORE
DEFAULT
CALIBRATION
MEASUREMENTS
1 In the Calibrator dialog box, click Restore Device.
2 Click OK to restore the preset default calibration set.
N
OTE
:
If the Apply to all calibration sets option is selected, all calibration sets on the server are
restored. If Apply to all calibration sets is cleared, Restore Device applies only to the
calibration sets selected under Customize.
calibration sets selected under Customize.