Xerox 7000AP 发行公告
28
Xerox CX Print Server 1.0 Release Notes
HCSS Front Staple Option Display
On the
Finishing
tab, under
Finisher options
, when you select
HCSS
and also select
the
Stack Tray
and
Stapler
options, the display of the
Front
position for the staple is
shown at an angle instead of straight. This is only a display issue. When the job is
sent to the stapler finisher, the direction of the staple will be straight.
sent to the stapler finisher, the direction of the staple will be straight.
Spire Print Driver Software
There are limitations when using the Print Driver software in the following
applications:
applications:
•
Microsoft PowerPoint—for Letter or A4 paper sizes, set the paper size in
PowerPoint. Set all other paper sizes in the PPD file.
PowerPoint. Set all other paper sizes in the PPD file.
•
QuarkXPress—for Letter or A4 paper sizes, set the paper size in QuarkXPress.
Set all other paper sizes in the PPD file.
Set all other paper sizes in the PPD file.
When using the above applications, before enabling the Print Driver software, go to
the Printer properties for the virtual printer and set the PPD page size to the
maximum size available.
the Printer properties for the virtual printer and set the PPD page size to the
maximum size available.
Backup and Restore Configuration
The configuration file can only be backed up to the default path,
C:\CXP8000\General\Configuration
.
If you are reinstalling the CX print server software or upgrading your CX print
server software version, your configuration file cannot be restored using the
server software version, your configuration file cannot be restored using the
DFE
Configuration recovery
option in
Step 1
of the Configuration Wizard.
To restore your configuration file, after the CX print server software has been
installed, go to
installed, go to
Tools > Settings > Administration
, and select
Configuration backup
.
Locate your configuration file and start the restore process.
Incorrect Print Status Information
The Printing status indicator becomes blank during a paper jam. It does not depict
the percentage or the number of pages that have completed printing.
the percentage or the number of pages that have completed printing.
Note: You can always use the PPD file instead of the Print Driver software. To use the PPD
file, disable the Print Driver software by selecting off in the Enable enhanced user
interface list. Refer to "Setting up the Print Driver Software"> on page 15, for more
information.
file, disable the Print Driver software by selecting off in the Enable enhanced user
interface list. Refer to "Setting up the Print Driver Software"> on page 15, for more
information.