Xerox 7000AP 补充手册

DocuColor 7000AP/8000AP Decurler Adjustment

2

Decurler Adjustment

With some print jobs, the output prints still may be curled more 

than you desire even after using the Decurler Paper Type A-D 

settings. In those cases, use the Decurler E Table Settings 

feature to compensate for paper curl in your prints. The Decurler E 

Table settings are based on job type and percentage of toner area 

coverage. These settings are manually entered. 

KEY POINT: If a Decurler profile setting is changed, it remains at 
that setting until changed again manually. As an example, if you 
decide to use the Paper Type B Decurler setting, the setting will 
remain at Paper Type B until you change it to another setting.

KEY POINT: It is important to remember that a successful 
Decurler setting used today may not be the same setting that you 
would use on another day for the same file. This is especially 
relevant if the room in which printer is located experiences 
changes in temperature and humidity.

The Decurler has both upper and lower adjustment arms that 

apply pressure to the paper based on system defaults, selections 

made on the Decurler Setup screen (Paper Type A-D settings), or 

based on entries made on the Decurler E Table Settings screen. 

The degree of pressure is applied independently to the upward 

and downward Decurler arms.