Xerox 4517 用户指南
R e p l a c i n g C o n s u m a b l e s
A p p e n d i x B : R e p l a c i n g C o n s u m a b l e s ❖ B-5
Replacing
the Fuser
Cartridge/BTR
Caution
•
The fuser area is extremely hot. Turn the printer OFF and
allow it to cool for 40 minutes before replacing an existing
fuser cartridge.
allow it to cool for 40 minutes before replacing an existing
fuser cartridge.
•
Replacing the BTR (Bias Transfer Roll) requires removing
the EP cartridge. Do not expose the EP cartridge to direct
sunlight or artificial light for more than 15 minutes.
Overexposure will permanently damage the
photosensitive imaging drum.
the EP cartridge. Do not expose the EP cartridge to direct
sunlight or artificial light for more than 15 minutes.
Overexposure will permanently damage the
photosensitive imaging drum.
1
Power OFF the printer and disconnect the power cord.
2
Open the rear cover.
3
Let the fuser area cool for 40 minutes.
If the Duplex Module is installed, continue
with Step 4 on page B-6. Otherwise, skip
to Step 5 on page B-6.
with Step 4 on page B-6. Otherwise, skip
to Step 5 on page B-6.
40
chapterb.frm Page 5 Friday, July 11, 1997 8:23 PM