Xerox 8400B 用户指南

 

 

 

with a particular icon file set, the Xerox-Generic icon is displayed. Models are 
mapped to icons based on the MIB II System Object Identifier. The Pmap.ini file 
is found in the  [Drive]:\[Install Directory]\  directory.   The [xerox_models] 
section of a sample Pmap.ini file follows.  

[xerox_models] 

count=5 

// 4512 

model1=1.3.6.1.4.1.253.8.62.1.2.1.1.1:xer_4512_normal.ico:xer_4512_green.ic

o:x er_4512_blue.ico:xer_4512_yell.ico:xer_4512_red.ico 

// 4517 

model2=1.3.6.1.4.1.253.8.62.1.2.2.1.1:xer_4517_normal.ico:xer_4517_green.ic

o:x er_4517_blue.ico:xer_4517_yell.ico:xer_4517_red.ico 

// DocuPrint C55 

model3=1.3.6.1.4.1.253.8.62.1.2.3.1.1:xer_c55_normal.ico:xer_c55_green.ico:

xer _c55_blue.ico:xer_c55_yell.ico:xer_c55_red.ico 

// DocuPrint N24 

model4=1.3.6.1.4.1.253.8.62.1.3.2.2.1:xer_n24_normal.ico:xer_n24_green.ico:

xer _n24_blue.ico:xer_n24_yell.ico:xer_n24_red.ico 

// DocuPrint N32 

model5=1.3.6.1.4.1.253.8.62.1.3.2.1.1:xer_n32_normal.ico:xer_n32_green.ico:

xer _n32_blue.ico:xer_n32_yell.ico:xer_n32_red.ico 

 

The sample shows a [xerox_models] section with 5 model to icon definitions. Each 
model statement consists of a valid MIB II System Object Identifier (SysObjID) 
concatenated with 5 icon file names of type ‘ico’. The SysObjID and file names 
are delimited by colons (‘:’). For best results each icon file should contain an icon 
easily associated with the Xerox mode being represented. Each icon file should 
contain icons of the following sizes:   32x32 and 43x43 pixels. Each icon file must 
represent one of the status conditions reportable by PrinterMap.    The file names 
must be in the following order: 

1.   Gray (Normal) Icon (This icon is not currently used by PrinterMap but is still 

required). 

2.   Green (Running) Icon 
3.   Blue (Unknown) Icon 
4.   Yellow (Warning) Icon 
5.   Red (Down) Icon