Xerox 128 服务手册
5 - 1 0
DocuTech 128/155/180 HighLight Color Operator Guide
Technical information
Do not use the following stocks:
•
Multipart forms
•
Stocks outside of the recommended size and weight ranges
Using non-standard stock
Using stock of non-standard width or length in the printer may
have a negative impact on system performance. Refer to the
following table for a listing of sizes and possible resulting impacts.
have a negative impact on system performance. Refer to the
following table for a listing of sizes and possible resulting impacts.
Table 5-6. Stock width impact on system performance
Textured paper
Heavily textured paper may produce prints
with a ragged character appearance or
deletions. To test, run a proof print.
with a ragged character appearance or
deletions. To test, run a proof print.
Window stock
Run if the window is 2.2 to 4 inches (57 to
102 mm) from the top edge of the paper and
at least 1 inch (25.4 mm) from each side of
the paper.
Run only as the first page or a front cover to
avoid finisher bin jams.
Load the window stock face-up into a tray
(tray 1 or 2 is recommended) with the top
edge toward the front of the tray.
If running plastic-covered window stock,
there may be some distortion. To test, run a
proof copy.
102 mm) from the top edge of the paper and
at least 1 inch (25.4 mm) from each side of
the paper.
Run only as the first page or a front cover to
avoid finisher bin jams.
Load the window stock face-up into a tray
(tray 1 or 2 is recommended) with the top
edge toward the front of the tray.
If running plastic-covered window stock,
there may be some distortion. To test, run a
proof copy.
Xerox Carbonless
Xerox Carbonless Paper is recommended.
Stock Type
Instructions for use
Stock width
Impact on performance
8.67 to 9 inches (221
to 229 mm) in trays 1,
2, 3, 4, and 5
to 229 mm) in trays 1,
2, 3, 4, and 5
Extended runs may increase the risk of
temporary background.
Increased risk of lead-edge image deletions on
each successive sheet.
Stock programming errors may go undetected
because stock width checking is not performed.
temporary background.
Increased risk of lead-edge image deletions on
each successive sheet.
Stock programming errors may go undetected
because stock width checking is not performed.
9 inches (229 mm) to
less than 14.2 inches
(361 mm) in trays 3,
4, and 5.
less than 14.2 inches
(361 mm) in trays 3,
4, and 5.
Image offset may occur following a printer
malfunction; for example, fuser jams.
Running stock wider than 9 inches (229 mm)
(other than 17 x 11 inches or A3) may increase
the risk of misregistration, skew, and tray 3
elevator problems.
malfunction; for example, fuser jams.
Running stock wider than 9 inches (229 mm)
(other than 17 x 11 inches or A3) may increase
the risk of misregistration, skew, and tray 3
elevator problems.