Xerox 128 服务手册
DocuTech 128/155/180 HighLight Color Operator Guide
3- 27
Routine maintenance
7. Close the processor doors.
The fuser blend message disappears after the system makes
approximately 20 prints.
approximately 20 prints.
Waste containers
The waste containers in the DT 128/155/180 HLC collect dry ink
and developer after it has been used by the printer. When a
container becomes full, it must be replaced or the printer
eventually stops printing. This section contains the procedures for
replacing the toner and developer waste containers.
and developer after it has been used by the printer. When a
container becomes full, it must be replaced or the printer
eventually stops printing. This section contains the procedures for
replacing the toner and developer waste containers.
Replacing the 128/155/180 HLC developer waste container
To replace the developer waste container:
1. Open the processor doors and locate the dry ink cartridge at
the lower center of the printer. The developer waste container
is located below and to the right of the color dry ink bottle.
is located below and to the right of the color dry ink bottle.
Figure 3-25 HLC developer waste container
2. Using your right hand, grasp the container by the handle on
top. With your thumb, depress the latch located above the
frame of the machine. Lift the edge of the container from the
tray and remove. Unscrew the cap from the front of the waste
container and use it to close the open end of the waste
container.
frame of the machine. Lift the edge of the container from the
tray and remove. Unscrew the cap from the front of the waste
container and use it to close the open end of the waste
container.
3. Discard the waste material and container appropriately.