Xerox 75 用户指南
Installation Planning Guide
Installation
DocuTech/DocuPrint 75/90 and DocuPrint 75 MX
4-15
4. Rotate the wire bracket down into place.
5. Tilt the back of the monitor upward.
6. Install the ends of the rear wire bracket into the rear two
holes. (The wire bracket crosses over the base of the
monitor.)
monitor.)
7. Rotate the wire bracket down into place.
8. Install the two retainers around the two wire brackets.
9. Secure the retainers using two 12 mm screws per
retainer.
•
Ensure that you have used the “In” and “Out” surge-
suppressor jacks when you re-established the modem
connections.
suppressor jacks when you re-established the modem
connections.
•
Plug the power strip into the wall receptacle.
•
Power on the controller using the correct power-on
procedure.
procedure.
•
Power on the printer using the correct power-on procedure.
Reenter the printer telephone number if it has changed and
inform the Welcome Center of the new number.
Reenter the printer telephone number if it has changed and
inform the Welcome Center of the new number.
•
Lock the printer casters in position by pressing the caster
wheel lever down.
wheel lever down.
Space requirements
The dimensions shown in Figures 4-8 and in
in this
chapter are also required when you relocate the controller and
printer.
printer.