Xerox 220e 参考指南

The following Þles control Sys/Start Job execution and apply only to the 
Phaser 220i.  

■

The Set SysStart Job (SYSTART.PS) Þle enables automatic execution 
of a Þle named SysStart (if one is found) on a hard disk connected 
to the printer's SCSI port, each time the printer is turned on or 
reset.  The Sys/Start job is similar to an Init Þle; it executes 
automatically each time the printer is switched on.

■

The No SysStart Job (NOSYSTRT.PS) Þle disables automatic 
execution of the Sys/Start job.              

Send one of these Þles to the printer to control Sys/Start Job execution.

*Available only on the Phaser 220i.

The Sys/Start Job Þles are compressed into the Phaser 220 
Utilities.sea archive Þle on the Macintosh Printer Utilities diskette, 
and must be decompressed before you can use them.  To 
decompress these Þles, follow the steps listed under the topic 
ÒDecompressing the Macintosh utility ÞlesÓ in Chapter 1, ÒBefore 
You Begin.Ó  After decompressing these Þles, continue with the 
steps listed below.  

Select the appropriate printer in the Chooser.  

Locate the Sys/Start Job Þles in the folder on your hard disk 
containing decompressed utility Þles.