Xerox 300x 用户手册

1

Reset/run

Up:  The printer resets and does not accept data while 
the switch is in this position.

Down:  The printer runs a self-test, then proceeds to run 
normally.  Leave the switch 

down for normal operation.

2, 3, 4

Configuration 
Page/
Diagnostics

Up:  When only Switch 4 is moved from down to up, the 
printer prints a configuration page.  See the table 
“Switches 2, 3, and 4: Diagnostics” on page 7-6.

5

Start Job

Up:  The Sys/Start job on the hard disk does not run.

Down:  The Sys/Start job runs if the file exists on the disk.

6

Set paper size

Up:  For metric-size media.

Down:  For American-size media.

7

Baud Rate

Up:  Fixed.  Sets the serial communication parameters to 
1200 baud, software flagging, and ignore parity.

Down:  Variable.  Lets you change the serial 
communication parameters.  The factory setting is 9600 
baud, software flagging, and ignore parity.

For information on how to change the serial port settings 
when Switch 7 is in the 

down position, refer to the 

Phaser 300X Drivers and Utilities Printing Reference for 
details on the setdevparams PostScript command.

8 and 9

Color 
Correction

See the table “Switches 8 and 9: Color Correction Mode” 
on page 7-6.