Xerox 300x 用户手册
2
Getting Set Up
2-4
Phaser 300X Color Printer
Loading paper
1.
Move the guides.
2.
Push down on the metal lift plate
with your finger; then slide the
paper under the tabs. When you
use A-size (8.5 x 11 in.) or A4-size
(210 x 297 mm) paper, place the
long side of the paper under the
tabs, making sure that the paper fits
snugly against the inside front wall
of the paper tray.
with your finger; then slide the
paper under the tabs. When you
use A-size (8.5 x 11 in.) or A4-size
(210 x 297 mm) paper, place the
long side of the paper under the
tabs, making sure that the paper fits
snugly against the inside front wall
of the paper tray.
3.
Adjust the rear guide until it
touches the rear of the paper.
touches the rear of the paper.
Note
The rear guide must fit snugly
against the paper; otherwise the
printed image might be clipped or
rotated.
against the paper; otherwise the
printed image might be clipped or
rotated.
4.
Put the cover on the paper tray.
5.
Insert the paper tray into the printer. Tilt the paper tray up slightly as you insert it.
Note
To load transparencies, refer to “Making transparencies” on page 3-36.
8873-03
A, A4
1
2
3
4
5