Xerox 300x 用户手册

The Phaser 300X supports PostScript Level 1 and Level 2 and HP-GL 
(Hewlett-Packard Graphics Language) printer languages. Additionally, the 
printer supports monochrome PCL5 (Printer Command Language) as a 
separately enabled option.  PCL5 requires 22 Mbytes of memory.

The following table shows the default language setting for each port.

If you want to use an HP-GL application on a PostScript port, you must 
explicitly set up that printer port for HP-GL data or enable Adobe 
IntelliSelect™ automatic language selection.  If you want to use a PCL5 
application, you must enable automatic language selection.  Refer to the 
Phaser 300X Drivers and Utilities Printing Reference.

If automatic language selection is enabled, you can change back and forth 
between HP-GL, PostScript, and PCL5 regardless of the default language.  
You can also change the default language so that the next time you turn on 
the printer, it expects to receive HP-GL, PostScript, or PCL5 data on a 
specific port.  

The printer has default values for the HP-GL parameters, such as pen color 
and pen width.  However, you can change these values.  Refer to “Changing 
the HP-GL default settings” on page 43 for more information.

Serial

PostScript

Parallel

PostScript

LocalTalk

PostScript

EtherTalk

PostScript

LPR

PostScript

AppSocket

Automatic Language Selection

NetWare

Automatic Language Selection