Xerox 3500 用户指南

To launch CentreWare IS:

Launch your web browser.

Enter your printer's IP address in the browser’s Address field (http://xxx.xxx.xxx.xxx). 

For detailed information about CentreWare IS software, click HELP on the upper right of 
the CentreWare IS screen.

Status Monitor is installed when you select Install Status Monitor while installing the printer 
software, and available only with Windows on a network-enabled or a USB cable-connected 
printer. It automatically checks the printer status and sends instant notifications to your 
computer if the printer needs attention.

Whenever the printer is unable to print a document, the printer automatically sends a message 
that indicates an error and provides the corresponding solution. Using Status Monitor, you can 
also access the HTML Troubleshooting Guide, which provides an animated message showing 
how to address the problem. You do this by double-clicking task bar or from the Windows 
Start menu.

To save energy, the printer enters a low-energy consumption mode after a predefined period of 
time has elapsed since its last activity. In this mode, called Power Saver, most printer electrical 
systems are shut down. When a print job is sent to the printer, the printer enters Warmup mode. 
You can also warm up the printer by pressing the OK button on the control panel.

If you find that the printer is going into the Power Saver mode too often and you do not want 
to wait while the printer warms up, you can increase the length of time before the printer goes 
into the Power Saver mode. Change the timeout value as follows:

On the control panel, press the Menu button, select 

, then press 

the OK button.

Select 

, then press the OK button.

Select 

, then press the OK button.

Press the Down Arrow or Up Arrow button to scroll to a selected Power Saver timeout 
value. Select a larger value if you want to extend the length of time before the printer goes 
into Power Saver mode.

Press the OK button.