Xerox 300x 用户指南
Calibrating the Printer
3
User Manual
3-27
Selecting calibration preferences
Note
The Calibration Preferences command is available only in the
Expert Calibration user mode. Refer to page 2-9 for instructions
on selecting this user mode.
Expert Calibration user mode. Refer to page 2-9 for instructions
on selecting this user mode.
You can change the active percentage points (but not the appearance of the
curves) in the Calibration Curves dialog box.
curves) in the Calibration Curves dialog box.
1.
From the File menu, select Preferences, then select Calibration
Prefs. The following dialog box appears:
Prefs. The following dialog box appears:
2.
Make a selection as desired.
■
The first row of numbers (10%, 50%, and 100%) is the default
setting. These percentages let you adjust colors in a light area, a
middle range, and in a dark area.
setting. These percentages let you adjust colors in a light area, a
middle range, and in a dark area.
■
The second row of numbers (5%, 10%, 25%, 40%, 60%, and 100%)
are the same percentage points used in the Gray Balance dialog box.
are the same percentage points used in the Gray Balance dialog box.
■
The User defined area lets you select individual percentages as
desired. For example, selecting 5%, 50%, and 90% would let you
adjust colors in highlight, midtone, and shadow areas.
desired. For example, selecting 5%, 50%, and 90% would let you
adjust colors in highlight, midtone, and shadow areas.
3.
Click OK.