Xerox 540 用户指南
Troubleshooting
6
User Manual
6-19
Media problems
Frequent paper-picking errors
■
Fan the paper or transparencies before installing them in their
respective trays. This is especially important for transparencies
because they tend to stick together.
respective trays. This is especially important for transparencies
because they tend to stick together.
■
Make sure that you have loaded the correct media in the tray. You
must load paper in the paper tray and transparencies in the
transparency tray.
must load paper in the paper tray and transparencies in the
transparency tray.
■
Make sure that the media is installed under the hooks at the front
of the media tray.
of the media tray.
Media is picked but does not advance
■
Check the front panel. If it reads
Wrong media in tray
, check
that the paper is loaded in the paper tray or transparencies are
loaded in the transparency tray.
loaded in the transparency tray.
Frequent media jams
■
Make sure that you use a high-quality laser paper:
75-105 g/m
75-105 g/m
2
(20-28 lb. ) paper in the media trays and
60-120 g/m
2
about media” on page 3-14 for more information.
■
Use only Tektronix transparencies that are listed on the supplies
information sheet. Tektronix does not guarantee the results of
non-Tektronix transparencies in Tektronix printers.
information sheet. Tektronix does not guarantee the results of
non-Tektronix transparencies in Tektronix printers.
■
Make sure that the media is installed under the hooks at the front
of the media tray.
of the media tray.
■
Do not overfill the media tray, as indicated by the red line on the
right side of the tray.
right side of the tray.
■
Never print on both sides of the media.