Xerox 6130 用户指南

Use each command according to the following rules.

■

Prefix all commands with “#”, and specify the #Password command at the top of the 
e-mail.

■

Command lines without “#” are ignored.

■

Write one command on each line and separate each command and parameter with a space 
or a tab.

When the same command is written two or more times in one e-mail, the second and 
subsequent commands are ignored.

When the read only password is “ronly”, and to check the printer status:

#Password ronly

#Status

When the full access password is “admin”, and to set the recipient e-mail address to 
“service@xerox.com”:

#Password admin

#SetMsgAddr service@xerox.com

When the full access password is “admin”, and to set the recipient e-mail address to 
“service@xerox.com”, then confirm the setting result on the network settings list:

#Password admin

#SetMsgAddr service@xerox.com

#NetworkInfo

Describe the “#SetMsgAddr” command before the “#NetworkInfo” command. If 

they are written in reverse, the information retrieved by the “#NetworkInfo” command and 
the result of executing the “#SetMsgAddr” command may differ.

#Password

Password

Use this command at the top of the e-mail when a password 
for read only or full access is set. You can omit this command 
when the password is not set.

#NetworkInfo

Set this when you want to check information on the network 
settings list.

#Status

Set this when you want to check the printer status.

#SetMsgAddr

Recipient E-mail 
address

Use this command to specify the e-mail address to which 
e-mail reports are sent to. This command can only be used 
when the full access password is specified by the #Password 
command.