Xerox 740 安装指导

To set up the printer for DNS, supply an IP domain name and up to two DNS 
name server IP addresses. There are three ways to set up the printer:

■

BOOTP (UNIX).  See “Setting IP parameters: RARP or BOOTP” on 
page 61.

■

DHCP (Windows).  See “Setting IP parameters: DHCP” on page 62.

■

With TCP/IP, you can use PhaserLink.  See the next topic, “Setting up 
the printer for DNS using PhaserLink software”.

After setting the printer’s IP address by one of the methods described 
previously in this chapter, you can set up the printer for DNS using PhaserLink 
software, if you have a World Wide Web browser.  For more information on 
PhaserLink software, see Chapter 9, “PhaserLink Software: the Printer’s 
Information Link”.

From the printer’s home page, click Configuration; this displays the 
View and Configure Settings

 page.

From the View and Configure Settings page, click View and 
Configure Interface Settings

; this displays the View and Configure 

 page.

From the View and Configure Interface Settings page, click View and 
Configure TCP/IP Settings

; this displays the View and Configure 

 page.    

Set the Domain Name Service Resolver Enabled field to Yes.

Enter the following information:

■

Primary Name Server IP Address (required)

■

Second Name Server IP Address (optional)

■

IP Domain Name  (required)

■

Additional Search Domain Name(s) (optional)

When you are finished entering the settings, enter the Validation 
Password

 and click Do/Apply. 

The printer displays a dialog box that allows you to reset the printer.  
New parameters will not take effect until the printer is reset.