Xerox 360 用户指南

Running the config-IP script

Connect the printer to a network.  ARP (Address Resolution Protocol) requires that 
the printer be connected on the same physical network segment as the host.

2.

Run the script config-IP:

In the directory where you placed your printer’s network utilities, change (cd) to 
the bin subdirectory. 

Type the name of the script, redirecting the output to a file.  Type:    

3.

Enter the information when prompted by the script.    

4.

Log in as root.

5.

Make an entry into the host’s ARP table defining the printer’s IP/hardware address 
pair.  In general, this requires a command corresponding to one of the following 
examples:     

6.

Turn on the printer.

7.

Execute the ping command from the host:

ping    printer-IP-address

8.

Use the host spooling system (for example, lpr or lp) to send to the printer the file you 
created in Step 2b.  This stores the IP addressing information in the printer’s internal 
memory, where it is retained over a reset or power cycle.  (For more information on 
setting up queues, see TCP/IP Host Configuration (UNIX) on page 24.)

9.

Reset the printer. 

config-IP  >   filename

Note

The script accepts IP addresses that have empty fields (for example, 
123..40.10).  The script does not detect this error.  Double-check the IP 
addresses you enter.

arp    -s    printer-IP-address    hardware-address        (for BSD systems)

                                 or

arp   -s   ether    printer-IP-address    hardware-address    (for System V)

See your host system documentation for specifics of this command.   

Note

The hardware address in the arp command example is the printer’s 
Ethernet Address for PhaserShare Ethernet interfaces or the Token Ring 
Address for PhaserShare Token Ring cards.