Xerox 360 用户指南
2
PhaserShare Networking Manual
Token Ring
Token Ring
Token Ring card
The printer can be connected to a Token Ring network using an optional Tektronix
PhaserShare Token Ring Card.
PhaserShare Token Ring Card.
The PhaserShare Token Ring port conforms to the IEEE 802.5 standard. With the
PhaserShare Token Ring card, you can connect the printer directly to a Token Ring
network using shielded twisted pair (STP; IBM Type 1) or unshielded twisted pair (UTP;
IBM Type 3) cables. Contact your dealer to obtain adapters and cables.
PhaserShare Token Ring card, you can connect the printer directly to a Token Ring
network using shielded twisted pair (STP; IBM Type 1) or unshielded twisted pair (UTP;
IBM Type 3) cables. Contact your dealer to obtain adapters and cables.
Note
To fully comply with EMI specifications, the use of shielded or screened cables
may be required.
may be required.
Shielded
describes IBM-defined cables used with the DB-9
connector.
Screened
describes cables that are electrically similar to Category 4
UTP, but with an added shield or screen.
When a PhaserShare card is purchased initially with the printer, it is installed at the
factory. When a PhaserShare card is purchased later as an upgrade kit, follow the
installation instructions that are shipped with the card.
factory. When a PhaserShare card is purchased later as an upgrade kit, follow the
installation instructions that are shipped with the card.
When a PhaserShare Token Ring card is installed in the printer, the printer’s built-in
Ethernet connector is disabled.
Ethernet connector is disabled.
Note
To avoid damaging the network interface, turn off the printer before making any
Token Ring connections.
Token Ring connections.