Xerox 8855 补充手册
XES Synergix 8855 Controller Setup Manual for Firmware 7.0
2
Setting the Controller Port Defaults
The AccXES controller will operate with one, two, or all ports active. A 10/100
Ethernet interface, supporting TCP/IP is standard on the controller.
Ethernet interface, supporting TCP/IP is standard on the controller.
To prepare the AccXES controller to print:
• Connect cables and interface devices to the appropriate ports, then refer
to Viewing the System Configuration Defaults section of this document
for instructions on activating the port(s).
for instructions on activating the port(s).
• Load your workstation with the desired client software to manage the job
flow to the selected port(s). The software manuals contain install
instructions for each of the platforms, so use the correct procedure.
instructions for each of the platforms, so use the correct procedure.
• Additional network setup information is contained in the XES Synergix
8825/8830/8855 Network Administrator’s Guide that was shipped with
your 8855 System.
your 8855 System.
Note: Changes to controller parameters require up to 60 seconds to be
written to the system memory. When setting changes have been made, and
especially after a Factory Default Reset, wait 60 seconds for the changes to
take effect.
written to the system memory. When setting changes have been made, and
especially after a Factory Default Reset, wait 60 seconds for the changes to
take effect.
Setting up the Ten Custom Print Job
Defaults
Defaults
Ten sets of custom job defaults may be assigned and stored for future use.
These custom job default values may be entered remotely. Use a workstation
with the appropriate software loaded (for example, Microsoft Internet Explorer
browser) to access the Web Printer Manager Tool. When using this method,
refer to the Web Printer Manager Tool (PMT) User Guide for the procedure
required to access the Miscellaneous Page of the Web PMT. The custom job
defaults are labeled "Active User Setup" on this page.
These custom job default values may be entered remotely. Use a workstation
with the appropriate software loaded (for example, Microsoft Internet Explorer
browser) to access the Web Printer Manager Tool. When using this method,
refer to the Web Printer Manager Tool (PMT) User Guide for the procedure
required to access the Miscellaneous Page of the Web PMT. The custom job
defaults are labeled "Active User Setup" on this page.