Xerox 3100MFP 用户手册

- 39 -

You can install the printer and scan drivers manually 
without running any setup software.

1 Locate your USB cable connectors and connect as 

shown below on the picture.

2 Power on your machine.

 

The PC detects the device.

3 Click on L

).

 

The following screen appears:

4 Open the CD-ROM drive, insert the installation CD-

ROM and close the drive.

 

The drivers are detected automatically.

5 Select X

EROX

 PHASER 3100MFP in the list and 

click on N

.

6 A screen informs you that the drivers have been 

installed. Click on the C

 button.

You can now use the machine to print and scan your 
documents.

Make sure that your machine is powered off. The 
connection between the PC and the machine requires a 
USB 2.0 shielded cable no more than 3 meters long.

1 Locate your USB cable connectors and connect as 

shown below on the picture.

It is recommended to install the 
Xerox Companion Suite software 
first and then to connect the USB 
cable to your machine (see 
Installing the full software 
package, page 36).

If you connect the USB cable before 
installing the Xerox Companion 
Suite software the recognition 
system (plug and play) identifies 
automatically that new hardware has 
been added. To start your machine 
drivers installation, refer to 
paragraph Installing the drivers 
manually, page 39 and follow the 
instructions on screen. When you 
use this procedure, only printing and 
scanning functions are activated.