Xerox 3100MFP 用户手册

- 2 -

1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio / TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

This Class "B" digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe "B" est conforme à la norme NMB-003 du Canada.

CAUTION: Use of controls, adjustments, or performance of procedures other than those specified in this guide 
may result in hazardous light exposure.

This equipment complies with international safety standards and is classified as a Class 1 Laser Product.

With specific reference to lasers, the equipment complies with laser product performance standards set by 
governmental, national, and international agencies as a Class 1 Laser Product. It does not emit hazardous light, 
as the beam is totally enclosed during all phases of customer operation and maintenance.

This machine complies with IEC 60825-1:1993+A1:1997+A2:2001 standard, is classified as laser class 1 product 
and is safe for office/EDP use. It contains one class 3B laser diode, 10.72 mW max, 770-795 nm and other class 
1 LEDs (280 µW at 639 nm).

Direct (or indirect reflected ) eye contact with the laser beam might cause serious eye damage. Safety precautions 
and interlock mechanisms have been designed to prevent any possible laser beam exposure to the operator.

CDRH Regulations.

This equipment complies with the FDA performance standards for laser products except for deviations pursuant 
to Laser Notice No.50, dated 24 June 2007 and contains 1 class 3B laser diode, 10.72 milliwatt, 770-795 
nanometer wavelength and other class 1 LEDs (280 µW at 639 nm).

This equipment does not emit hazardous light, since the beam is totally enclosed during all customer modes of 
operation and maintenance.

Your Xerox equipment and supplies have been designed and tested to meet strict safety requirements. These 
include safety agency examination, approval, and compliance with established environmental standards.

To ensure the continued safe operation of your Xerox equipment, follow these safety guidelines at all times:

• Always follow all warnings and instructions that are marked on or supplied with the equipment.

• Before cleaning this product, unplug the product from the electrical outlet. Always use materials specifically 

designated for this product, the use of other materials may result in poor performance and create a hazardous 
situation.

• Always exercise care when moving or relocating equipment. Please contact your local Xerox Service Center to 

arrange relocation of the copier to a location outside of your building.