Xerox 6110MFP 用户手册

.5   

<Troubleshooting>

Open the fuser door. 

Locate the jammed paper and pull it out.

Close the fuser door.

Close the rear cover. Printing automatically resumes.

By selecting the correct media types, most paper jams can be avoided. 
When a paper jam occurs, follow the steps outlined on page 14.2. 
• Follow the procedures on page 5.6. Ensure that the adjustable guides 

are positioned correctly.

• Do not overload the tray. Ensure that the paper level is under the 

brackets of the tray 1.

• Do not remove paper from the tray while your machine is printing.
• Flex, fan, and straighten paper before loading. 
• Do not use creased, damp, or highly curled paper.
• Do not mix paper types in a tray.
• Use only recommended print media. See page 5.2.
• Ensure that the recommended print side of print media is facing up in 

the mamual tray and tray 1.

fuser door

Messages appear on the control panel display to indicate the machine’s 
status or errors. Refer to the tables below to understand the messages’ 
meaning and correct the problem if necessary. Messages and their 
meanings are listed in alphabetical order.

Messages in the coloured cells are available only with Phaser 
6110MFP/XN

. 

• When you call for service, it is very convenient to tell the 

service representative the display message.

The colour toner 
cartridge has run 
out. The machine 
stops printing.

Replace the colour 
toner cartridge with a 
new one. See page 
13.5

The corresponding 
colour toner 
cartridge is almost 
empty.

Take out the toner 
cartridge and 
thoroughly shake it. 
By doing this, you can 
temporarily 
reestablish printing 
operations.

The machine 
received several 
papers with many 
images, and it can 
not supply the toner 
properly.

Unplug the power 
cord and plug it back 
in. If the problem 
persists, please call 
for service.

The machine has a 
communication 
problem.

Ask the sender to try 
again.

The machine has 
received a fax from 
which is registered 
as a junk fax.

The received fax data 
will be deleted.
Reconfirm junk fax 
setup. See page 10.2

Your machine cannot 
connect with the 
receiving fax 
machine or has lost 
contact because of a 
problem with the 
phone line.

Try again. If the 
problem persists, wait 
an hour or so for the 
line to clear and try 
again.
Or, turn the ECM 
mode on. See page 
10.1.

The receiving fax 
machine has not 
answered after 
several redial 
attempts.

Try again. Make sure 
that the receiving 
machine is 
operational.