Xerox 3200 用户手册
3 Network Setup
3-2
Xerox Phaser 3200MFP
Introduction
Once you have connected your machine to a network with an RJ-45 Ethernet
cable, you can share the machine with other network users.
You need to set up the network protocols on the machine to use it as your
network printer. Protocols can be set up by the following method:
cable, you can share the machine with other network users.
You need to set up the network protocols on the machine to use it as your
network printer. Protocols can be set up by the following method:
Via the control panel
You can set up the following basic network parameters through the machine’s
control panel:
control panel:
•
Configure TCP/IP
•
Configure EtherTalk
Supported operating systems
The following table shows the network environments supported by the
machine:
machine:
•
TCP/IP: Transmission Control Protocol/Internet Protocol
•
DHCP: Dynamic Host Configuration Protocol
•
BOOTP: Bootstrap Protocol
Item
Requirements
Network interface •
10/100 Base-TX
Network
operating system
operating system
•
Windows 98/Me/NT 4.0/2000/XP(32/64bit)/2003(32/
64bit)/Vista
64bit)/Vista
•
Various Linux OS (refer to Installing the Unified Linux
Driver on page 32)
Driver on page 32)
•
Macintosh OS 10.3~10.4
Network
protocols
protocols
•
TCP/IP on Windows
•
EtherTalk
Dynamic
addressing server
addressing server
•
DHCP, BOOTP