Xerox 123 用户指南

This chapter explains how to set up the machine to operate on an EtherTalk network. 
The following information is provided.
Information Checklist – page 67
EtherTalk Environments – page 68
EtherTalk Installation – page 68
Installation Procedure – page 68
Network Communication Setup – page 68
Workstation Setup – page 70
Test Print – page 70

Before installing EtherTalk on the machine, make sure that the following items are 
available or have been performed.

If problems are encountered during the machine installation, refer to Problem Solving 
chapter for assistance.

An existing operational EtherTalk network with Macintosh workstations 
equipped with Ethernet network interface cards is required. These 
procedures are not designed to install an EtherTalk network.

Customer

Macintosh System versions 7.5 or later, 8.x, 9.x, or Mac OS X 10.2

Customer

Obtain and record the following information:
• IP address
• Gateway address
• Subnet mask
• Host name
Refer to the glossary for additional information about the Gateway 
Address and Subnet mask, if needed.

Customer

Test the machine to make sure that it is installed fully and functioning 
correctly.

Customer

Install the Adobe PS print driver, or PPD (optional).

Customer