Xerox 4150 用户指南

If your WorkCentre is a 4150s, 4150x or 4150xf, follow these instructions to connect the 
WorkCentre to an Ethernet TCP/IP network.
If you are connecting your WorkCentre to a different type of network, or you wish to use 
other protocols, refer to the System Administration CD.

Before connecting the WorkCentre to your network, make sure that it is operating correctly 
as a copier.

Place a document in the Document Feeder and make 3 copies.

If the copies are made successfully, install the network connection as described in the next 
steps. If copying is not successful, refer to Troubleshooting on page 31.

You can set up the TCP/IP network connection using either of the following methods:
• DHCP: Use this method to allow a DHCP server to automatically assign an IP address. 

This is the factory default setting.

• Static IP address: Use this method to manually assign an IP address provided by the 

network administrator.

When the WorkCentre is powered on, it automatically uses DHCP to obtain its network 
configuration. To use a static IP address, DHCP must be turned off and the IP address, 
gateway address, subnet mask, and DNS Server address must be entered manually.

Connect the Ethernet cable to the RJ45 connector 
on the WorkCentre. 

Continue on to the next step to setup the address 
using DHCP. If you want to set a static IP address, 
skip to Network Setup Using a Static IP Address on 
page 10.

After the WorkCentre starts, it negotiates with the DHCP server for an IP address. Wait two 
minutes for the network setup to complete and then check the allocated IP address as 
follows:

• On the Control Panel, select the Access button and then enter the Administrator 

passcode [1111] and select Enter.

• Select Go to Tools > Connectivity and Network Setup > Network Setup > TCP/

IP Options > TCP/IP Settings.

• The allocated TCP/IP address is in the Name/Address field.