Xerox 7132 用户指南

Enable the following ports using the touch screen or CentreWare Internet Services.

• Printing through LPD: LPD port

• Printing through Port9100: Port9100 port
Set the IP address using the touch screen.

This requires the workstations in the networking environment to be configured to 
communicate with the machine.

A print job should be submitted to make sure that the machine has been installed and 
configured correctly.

This section describes how to set up the network communication parameters of the 
machine.
At the machine, perform these steps.
NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP 
network.

NOTE: Some of the configuration options for this protocol are only available from the 
CentreWare Internet Services. Refer to the CentreWare Internet Services chapter of 
the User Guide.

Initially, boot the LPD port or Port9100.

Connect the machine to the network.

Display the [System Settings] screen.

NOTE: For more information about how to display the [System Settings] screen, refer 
to the Setups chapter of the User Guide.

Select [Network Settings].

Select [Port Settings].

If you are using the LPD port, select [LPD] and [Change Settings]. If you are using 
Port9100, select [Port9100] and [Change Settings].

If you are using the LPD port, select [Port Status] and [Change Settings]. If you 
are using Port9100, select [Port Status] and [Change Settings].

Select [Enabled] and [Save].