Xerox 7132 用户指南

This chapter explains how to set up the machine to operate in a Windows TCP/IP 
environment. The following information is provided.
Quick Network Setup (DHCP) – page 41
Quick Network Setup (Static IP) – page 42

Confirm that an existing operational network utilizing TCP/IP is available.

Confirm that the Ethernet cable is plugged into the multifunction machine and into 
an operational Ethernet port on the network.

NOTE: The Ethernet cable is an RJ45 type and is not supplied by Xerox.

On startup, the multifunction device defaults to DHCP to obtain its network 
configurations. A DHCP server delivers an IP address, as well as other configuration 
settings to the machine. If you use a DHCP server to allocate an IP address to the 
machine, then proceed as follows:

Power on the machine.

Wait a minute or so while the machine negotiates an IP address.

Print the System Settings List.

1) Select the <Machine Status> button on the machine.
2) Select [Print Report/List].
3) Select [Print Mode Settings].
4) Select [Setting List - Common Items].
5) Press the <Start> button on the machine.

Read the System Settings List to confirm that an IP address has been allocated 
and that it is a valid IP address on your network.

NOTE: If the IP address starts with 169.xxx.xxx.xxx, then the DHCP server has not 
properly allocated an address or DHCP is not enabled on your network.