Xerox 7228 用户指南

13 

The Device's Ethernet Interface has speed settings of Auto (10 BASE-T/100 BASE-TX), 100 BASE-TX 
(Half or Full Duplex), and 10 BASE-T (Half or Full Duplex).  By default the Ethernet Port Configuration will 
be set to Auto. 

To Change the Network Speed 

1. Press 

the 

 on the Control Panel. 

2. Press 

the 

on the numeric keypad five consecutive times.  (This is the factory default 

"password.") 

3.  Press the rectangular Confirm button on the touch screen. 

4. Press 

the 

 (the right-hand button of the two buttons displayed on the touch 

screen).  Note:  If you press the left button by mistake, the Main menu will be displayed and you will 
have to start over at step one above. 

5. Press 

the 

. 

6. Press 

the 

. 

7. Press 

the 

. 

8.  When the Protocol Settings menu displays, press the selection line labeled Ethernet Setting. 

9. Press 

the 

. 

10.  On the Ethernet Setting screen note which one of the buttons is highlighted as the current setting for 

Ethernet speed.  The available settings are Auto (10 BASE-T/100 BASE-TX), 100 BASE-TX (Half or 
Full Duplex), and 10 BASE-T (Half or Full Duplex).  The default setting is Auto. 

11.  To change settings, press your setting of choice, then click the Save button. 

12.  To exit the Ethernet Setting screen, without making any changes, click the Cancel button. 

13.  To exit the Protocol Settings menu, returning to the Device's Main screen, press the rectangular 

 button.  Next, press the rectangular Close button in the upper right corner of the Network 

Settings screen.  Press the rectangular Close button in the upper right corner of the System Settings 
screen.  Finally, press the rectangular Exit button in the upper right corner of the System Settings 
screen. 

14.  Note that if you changed any settings in the Protocol Settings menu, the Device will automatically 

reboot to register and enable your new settings.